|
POR-15 High Temperature Coatings
Black Velvet, Factory Manifold Gray and POR-20 Brilliant Aluminum are Very High Heat-Resistant Coatings
designed for use on steel subject to elevated temperatures. Factory Manifold Gray and POR-20 will withstand temperatures on a continuing basis up to 1400°F, while BLACK VELVET will will withstand temperatures
on a continuing basis up to 1200°F. When subjected to high heat concentrations,
Factory Manifold Gray will darken in color (as will cast-iron).
Though they will dry to the touch in about four(4) hours and may be handled,
these coatings will not arrive at full cure until they have been exposed
to heat concentrations of at least 300 degrees Fahrenheit.
Metal Preparation: Surfaces to be
coated must be clean, dry, and free from oil, grease, and any other coating
which cannot resist high temperatures (paints, varnishes, lacquers, metal
prep coatings, etc). Sandblasted surfaces are ideal, as are wire-brushed
or sanded or filed surfaces. Surgical-type gloves should be worn for handling
to keep natural body oils off the prepared surface.
Uses: Manifolds, Exhaust Systems, Ovens,
Stacks, Stoves, Headers, Boilers.
Product Characteristics
| Boiling Point: | 312 - 385 | | Vapor Pressure (mm Hg): | 3.9 PSIA @ 163* | | Vapor Density: | 5.00 | | Reactivity in Water: | None | | Solubility in Water: | Negligible | | Appearance & Odor: | Clear & Characteristic | | Specific Gravity (H2O=1): | 0.9076 | | Melting Point: | N/A | | Flash Point: | 108°F | | Method Used: | TCC | | Auto Ignition Temp: | 475 | | Extinguishing Media: | Foam, CO2, Chemical, Sand | | Flammable limits in Air % by Volume: | LEL Lower: 0.77
UEL Upper: 6 |
Product Description
Thinner: For brush or spray, use
only POR-15 Solvent. Lacquer thinner may be used for cleanup as may other
aromatic solvents.
Dry Time: At 75 degrees Fahrenheit
(24 degrees C), dry time is about four (4) hours to touch. Recoating may
be done after a minimum of 24 hours. Attains full cure only after heat
exposure of at least 300° Fahrenheit.
Special Application Technique
 Stir all POR-15 High Temperature coatings thoroughly before and often during application.
DO NOT SHAKE.
Apply in FULL coats rather than THINS
coats, but not so full that it runs.
Avoid going over the same area again after
it has been coated.
Keep away from heat, sparks, flame.
Use only in well-ventilated areas.
Avoid breathing vapors or spray mist,
contact with eyes and skin.
|
